Simple Steps to Reset the Check Engine Light

Different indications indicate car problems. The engine clicking and ticking or physical damage might indicate many car problems. Check engine light (CEL) illumination can easily detect complex or concealed defects. Reset this or your car’s pollution test will fail. This light should be off.

Make sure you’ve fixed the problem before trying to reset the check engine light. This will reveal check engine light causes.

What Sets the Engine Check Light?

Source: wikihow


Know the cause before fixing an issue. This applies to cars. As said, the engine check light alerts drivers to electrical or mechanical issues. Engine errors may cause it. Check for engine slipups before continuing. If your engine is fine, investigate other parts. Possible engine checks light causes:

  • Defective Oxygen Sensor
  • Bad Catalytic Converter
  • Vacuum leakage
  • Loosened Gas Cap
  • Defective Thermostat

Resetting an Engine Check Light: A Guide

Source: caranddriver

If your check engine light comes on, examine for causes. Find out why your check engine light is on.

After 20–30 cycles, the check engine light should reset after finding and addressing the issue. This may be three days. The process of starting a car, driving it till it heats up, then turning it off is repeated 10 or 30 times.

If the light persists, use a code reader or scanner to reset it. Using the other techniques, you can reset the check engine light without a scanner.

OBD 2 Scanner Use

This scanner can read and remove trouble codes, so you may not require a repair for every automotive problem. Because it detects and offers solutions. Scan tools that disable check engine lights include:

  • SeekoneObd 2 scanner
  • Autophix Obd2 improved code reader.
  • The final version code reader improved.
  • Foxwell OBD-II code reader Schwaben.
  • Starting Cr319 obd2 scanner
Also Read:  Exploring Conventional Differential Mechanics in Drivetrain Dynamics

Code reader check engine light reset;

  • Find your onboard diagnostic connector under the steering wheel. Then attach the code reader.
  • Start the engine and hit the scanner’s red button.
  • Several faults will appear; note down and store these trouble codes.
  • Use your car’s owner’s manual to decipher those codes.
  • The problem is found immediately after decoding the difficulty codes.
  • Fix any issues yourself or take them to a repair (the codes you typed down will save them time). Replace damaged parts.
  • Once done, hit the scanner’s clear or erase button to remove error codes.
  • Turn off and on your ignition after fixing the problem. Check the engine check light for presence or absence.
  • Repeat your scanner test to determine if it gives the same fault codes.

Detaching Battery

Resetting the check engine light without a scanner is quick and uncomplicated. This strategy works for some automobile models but not others. However, to do this:

  • Turn off the ignition.
  • Remove automobile battery terminals with a socket wrench. Set your sockets in case you need them.
  • The battery will retain some power. Press your car’s horn for 35 seconds to drain this power.
  • Reconnect battery cables after 20 minutes.
  • The check engine light should go out. If not, other difficulties may not be resolved. Expert mechanics can inspect the car.

Ignition On/Off

Again, this turns off the check engine light easily. To accomplish this,

  • Turn your ignition off and on.
  • Give it time.
  • Turn your ignition off and on again. Four or five times.
  • Drive and see if the check engine light goes out.
Also Read:  How to Reset Mass Air Flow Sensor?

Fuse Removal and Reinsertion

Another way to disable check engine lights is to remove and reinstall the engine control unit fuse. The process is quick and simple.

Recently made autos may not function with this strategy. It may work for older automobiles.

Leave a Comment