The transponder chip in your transponder key uses radio waves to communicate with your car’s ignition system, allowing you to access your vehicle with a one-of-a-kind set of numerical numbers. Your vehicle’s ignition will be turned on with the codes that are given.
Without that initial key that has been programmed, no car that is transponder key capable will operate. You may be asking what to do in the event that you lose all of your original keys. Stop freaking out. If you’ve misplaced your transponder key and need to program a replacement, we’ll show you the ropes.
How to program your transponder key without the original? Step by Step process.
You should be aware that a car that has a transponder key cannot start without the key. If you don’t have the original key, a master key, or the information needed to make a transponder key, your best bet is to consult a locksmith, your vehicle dealer, or both.
Programming a transponder key requires the original. Consider that many vehicles pose a safety risk if you are able to do so. However, your car doors can be opened by any key that lacks the proper programming.
Obtaining the correct transponder key programming is essential for starting your vehicle’s engine system using transponder key bypass. Only vehicles equipped with the PATS 1 system can have a spare transponder key programmed without the original key.
The procedure is straightforward. When all original keys are lost, a special programming device is required for vehicles equipped with the PATS 2 system. Nonetheless, it is possible to make a copy of a transponder key for any make or model of car.
You had previously cut a new transponder key for your vehicle, and it is equipped with the PATS 1 system. After that, you won’t need anyone else’s assistance with the programming.
Simply placing your key into your car and putting it into program mode should allow you to program your transponder key. A transponder key and the handbook for your car are all that’s needed. You can save both time and money if you follow the instructions below to do this.
Please ensure that your vehicle’s battery is capable of handling the prolonged battery life required to program a new transponder key before proceeding with the programming processes. For example, you’ll need to begin the process all over from the beginning if your battery dies while programming.
Pay close attention to these procedures if you need to program a transponder key for a Ford car without an origin that has a PATS 1 system. Remember that you need a transponder key that is specific to your vehicle model—we covered that before. Otherwise, there’s no point in going through with it. A toolbox for mechanics is unnecessary.
First Step:
To activate the transponder key, insert it into the ignition and turn the key on. After that, give it approximately 10 minutes and 25 seconds to remain on. Keep an eye on the dashboard; the security light should come on as you turn the key to start the engine. There must be an issue with your vehicle’s battery if you discover the security system did not activate. The battery can be charged or replaced.
Second Step:
Your security light should remain on for around fifteen minutes after turning on. To determine how long this will take, you can use a clock or stopwatch. This requires extreme caution with regard to time if you want to succeed. Take note of the time.
Third Step:
You should see the security light turn off once the 15 minutes are up. The three-minute interval between rotating the transponder key to the OFF position and turning it back to the ON position is required to disable the ignition. Your security system should activate once more and remain on for around fifteen minutes before turning off.
Fourth Step:
Within three minutes of the security system turning off again, you must reverse the orientation of your key from ON to OFF. After another fifteen minutes, your security light will turn off. You should be able to program your new transponder key to your vehicle when the security light shuts off after 45 minutes.
